Ferrite Bead Installation
1-Wire Indoor Sensor/Interface Kit

Refer to the layout diagram for clarification of parts placement. All references to up, down, left, and right assume that you are looking at the PCB with the silkscreen TAPR logo oriented up on the board. Unless noted otherwise, all components are mounted on the top of the PC board.

Ferrite beads have a cylindrical shape with a hole through the middle. String a ferrite bead on a clipped lead from the resistors previously installed.

Position the ferrite bead over the silkscreen outline and insert the leads into the solder holes. Spread the leads on the bottom side of the board apart slightly to hold the bead in place. The round side of the bead should rest flush against the top of the circuit board. Solder and clip the leads flush on the bottom of the board only when instructed to do so.

Ok
Procedure
  Ferrite bead at L1.
  Ferrite bead at L2.
  Ferrite bead at L3.
  Solder and clip six leads. Wear safety glasses and observe proper precautions!
 
  Ferrite bead at L4.
  Ferrite bead at L5.
  Ferrite bead at L8.
  Solder and clip six leads. Wear safety glasses and observe proper precautions!

Next