System Configuration Options
1-Wire Indoor Sensor/Interface Kit

T-238 Example Option 2
WXN Example Option 1
WXN Example Option 2
WXN Example Option 3

NOTE: To get a good perspective on the possible combinations, review all configurations. These are presented as just a few that are possible.

T-238: Example Option 1

In this configuration, the EMP sensor and rain gauge interface is installed on the outside sensor/interface board, the X1W-2. If you construct the rain gauge heater, note that a power cable will be required in addition to the 1-Wire cable. Note that the EMP sensor and rain gauge must be on the same board. They cannot be separated.