Diode Installation
1-Wire Outdoor Sensor/Interface Kit

Refer to the layout diagram for clarification of parts placement. All references to up, down, left, and right assume that you are looking at the PCB with the silkscreen TAPR logo at the lower right-hand side of the board. All components are mounted on the top of the PC board.

Diodes are polarity sensitive devices. The cathode end of the diode is banded and corresponds to the banded silk-screen legend on the PC board. If you have never worked with these devices, take a look at the photograph showing the banded ends.

Do not solder/clip leads until instructed to do so.

Ok
Procedure
  Install a BAT42 at D2.
  Install a BAT42 at D3.
  Solder and clip four leads. Wear safety glasses and observe proper precautions!

Next