Order Tray | Contact Us | Home | SIG Lists

[aprssig] Persist and Slottime for Digi?

hasan schiers schiers at netins.net
Sat Apr 2 21:36:16 UTC 2005


This is for UI-DIGI firmware in a TNC-2. I just set Persist for 255 and 
Slottime to 1, it would not accept a slot time of 0, the minimum is 1.

It would not accept, (nor is there any mention in the text file for 
programming the prom) any parameter like DWAIT, UIDWAIT.

So, I'll see if the persist and slot time commands make any difference.

thanks for the tip.

73,

...hasan, N0AN
----- Original Message ----- 
From: "Greg Noneman" <greg at clubnet.net>
To: "TAPR APRS Mailing List" <aprssig at lists.tapr.org>
Sent: Saturday, April 02, 2005 12:00 PM
Subject: Re: [aprssig] Persist and Slottime for Digi?


> Hassan,
>
> You didn't mention what type of TNC you were using.  For TNC2 units 
> (including UIDIGI firmware), if PPERSIST is ON, than PERSIST should be set 
> to 255 and SLOTTIME should be set to 0. DWAIT should also be set to 0. 
> For KPC 3 units, the same applies, but the more relevant parameter is 
> UIDWAIT, which must be set to OFF.  A UIDWAIT setting of OFF disables and 
> any delays (DWAIT, SLOTTIME) for packets covered by the UIDIGI, UIFLOOD or 
> UITRACE.
>
>
> 73,
> Greg
> WB6ZSU
>
>
> On Apr 2, 2005, at 9:03 AM, hasan schiers wrote:
>
>> What is the recommended Persistence and Slottime for digi's?
>>
>> I think Slottime is 0
>> What is the Persistence set to, 0 or 255 ?
>>
>> This is based on what Bob has recommended for digi's to be first on the 
>> channel.
>>
>> TIA
>>
>> ..hasan, N0AN
>
>
> _______________________________________________
> aprssig mailing list
> aprssig at lists.tapr.org
> https://lists.tapr.org/cgi-bin/mailman/listinfo/aprssig
> 






More information about the aprssig mailing list