[aprssig] battery enclosure.
Rich Garcia k4gps at arrl.netSun Apr 24 17:56:14 UTC 2005
- Previous message: [aprssig] battery enclosure.
- Next message: [aprssig] battery enclosure.
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
OK I guess since it is an airtight box I can see the difference in price. I have run batteries in the past to power my HF station when I was poor and could not afford a large power supply but did have a deep cycle charger and a crawl space under the house. It worked quite well for the 3 years we lived there, in the searing heat of summer and the snow of winter. But I agree Boyd now if I were to go backup battery the sealed batteries are much better, larger and affordable. My APRS setup is a shambles now after the 2 Hurricanes that came through last year and we are not planning on staying much longer in the area. Once I can transfer to the Carolina or TN region we will be making the move, hopefully by end of summer. At that time I plan on rebuilding the shack, gateway, and weather station. A nice size sealed battery power supply is in the plans for my entire station. It's just a matter of time, for right now my entire life is on hold pending a move. Now I know what it must be like living a military lifestyle, don't set roots or do much, you may be moving tomorrow and have all that work go to waste! Rich -----Original Message----- From: aprssig-bounces at lists.tapr.org [mailto:aprssig-bounces at lists.tapr.org]On Behalf Of Boyd D Garrett Sr Sent: Sunday, April 24, 2005 1:40 PM To: TAPR APRS Mailing List Subject: Re: [aprssig] battery enclosure. I think the key here is "airtight," Rich. If you keep a standard wet cell deep cycle battery inside the passenger compartment, and it's hooked up to charge from your alternator, that nasty gas build-up could potentially cause a few problems. Especially if someone smokes in the vehicle. But it seems to me that the box's shortcomings still argue against it. It accommodates a Group 24 battery, so if you have a 27 or 30 or whatever, it won't fit. Further, the box comes with vent tubes to get the gases out. If you use one of these, you'd have to find a way to run the tubes outside the passenger compartment, or it does you no good. All in all, I think I'd prefer to just use a sealed battery, such as an AGM, if I needed to keep it inside. 73, Boyd / N5CTI P.S. Sorry for continuing the digression from APRS, but sometimes I just can't shut myself up! Rich Garcia wrote: >$90 sounds a bit steep. May want to check out WestMarine and similar dealers >also since they are used >on personal watercraft also and if I remember correctly much MUCH less >expensive. > >Rich > >-----Original Message----- >From: aprssig-bounces at lists.tapr.org >[mailto:aprssig-bounces at lists.tapr.org]On Behalf Of Wes Johnston >Sent: Sunday, April 24, 2005 10:34 AM >To: TAPR APRS Mailing List >Subject: [aprssig] battery enclosure. > > >Anyone with a van wanting to keep a battery inside might want to use an >air tight box made by moroso for racing. It has 6 bolts around the >perimeter to hold down a gasketed lid and has provisions for a vent >tube. Runs about $90 at many "race car" dealers.... just google >"mor-74050" . > >Wes > >_______________________________________________ >aprssig mailing list >aprssig at lists.tapr.org >https://lists.tapr.org/cgi-bin/mailman/listinfo/aprssig > > > >_______________________________________________ >aprssig mailing list >aprssig at lists.tapr.org >https://lists.tapr.org/cgi-bin/mailman/listinfo/aprssig > > > > _______________________________________________ aprssig mailing list aprssig at lists.tapr.org https://lists.tapr.org/cgi-bin/mailman/listinfo/aprssig
- Previous message: [aprssig] battery enclosure.
- Next message: [aprssig] battery enclosure.
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
More information about the aprssig mailing list
