Order Tray | Contact Us | Home | SIG Lists

[aprssig] Kantronics KPC3+ Issue

Robbie - WA9INF mwrobertson at comcast.net
Wed Dec 7 16:07:23 UTC 2005


Duffy,

I have had extremely little experience with the AGAPE program, but 
understand it is great.

I would however be concerned with the handshake, that might tell the tnc 
to wait, and then never give it "Clear to send" signal.. I don't know.

I do know, when I stop a software program that's communicating with my 
tnc's, after a while the con led lights up until I either start the 
program again, or reset the tnc..

Robbie

Amateur Radio WB8NUT wrote:
> AGWPE is connected to TNC and then the applications are go to the TNC 
> via AGWPE.  Allows multiple applications to access the TNC at the same 
> time.  So, I am a bit ignorant that what I have possibly misconfigured.  
> What should I look for and where?
> 
> Thanks,
> 
> Duffy
> 
> Robbie, wa9inf wrote:
> 
>> Duffy,
>>
>> If I am not mistaken, it would indicate the pc, or software is not 
>> allowing communications from the tnc and the buffer of the tnc is 
>> full.. You may have the port misconfigured??
>>
>> Robbie






More information about the aprssig mailing list