[aprssig] PCB-88

[Bob Donnell]

Hi Paul,

As a former AEA customer support staffer, and having been involved in APRS for 
a few years, I'm not aware of any after-market firmware that can be plugged 
into a PCB-88 (which from a firmware point of view, is identical to a PK-88) 
to improve its capabilities in a way that improves APRS operations.  However 
by running DigiNED on the computer that the PCB-88 is installed into, you can 
have about the most capable APRS digipeating software in existence.

Hope that helps!

73, Bob, KD7NM


On Wednesday 28 December 2005 09:18, K.Paul Boggs wrote:
> Can a PCB-88  (in commputer board) be used as a Digi ?
> If so which chip is replaced or re-burned ??
> Any oyher hints ?
> Thanks in advance
> Paul0
>
>
> K.Paul Boggs
> ab6wu at earthlink.net
> Mountain Emergency Communications