Order Tray | Contact Us | Home | SIG Lists

[aprssig] SATGATE setup Help needed

Andrew Rich vk4tec at tech-software.net
Sun Feb 6 16:58:59 UTC 2005


Spot on Pete !


Hey so tell me this, should I still use 

d/RS0ISS/W3ADO-1/PCSAT b/W3ADO-1/PCSAT-11/PCSAT-12 on any definable filter port ? en aprs.net.au 14580 

or 

xxxx on socal.aprs.net 




-----Original Message-----
From: AE5PL Lists [mailto:HamLists at ametx.com]
Sent: Monday, 7 February 2005 2:49 AM
To: TAPR APRS Mailing List
Subject: RE: [aprssig] SATGATE setup Help needed


This description is a little bit deceiving.  Port 10149 on aprs.net.au is a read-only port (note TX only on the status page).  What this means is that it only sends data to the client.  In this case, it has a predefined filter of "d/RS0ISS/W3ADO-1/PCSAT b/W3ADO-1/PCSAT-11/PCSAT-12"  Therefore it cannot accept data from the client so it tries to hint at this by only allowing unverified connections.

Try socal.aprs2.net port 10150 or any user defined filter port (14580 on most javAPRSSrvr servers).  Be sure to set UI-View to NOT gate to RF.

73,

Pete Loveall AE5PL
mailto:pete at ae5pl.net 

> -----Original Message-----
> From: Andrew Rich
> Posted At: Sunday, February 06, 2005 10:17 AM
> Subject: [aprssig] SATGATE setup Help needed
> 
> I get unverified. I am keen to help out.
> 
> Where should I and how should I setup my ui-view station to 
> act as a satgate ?





More information about the aprssig mailing list