[aprssig] agwpe and d700

[Ryan Tourge]

Use a terminal program and connect to the tnc in packet tnc mode. Issue KISS
ON and then power cycle, STA will blink... ready to run in kiss mode. As for
the AGWPE part I have no clue


-----Original Message-----
From: aprssig-bounces at lists.tapr.org [mailto:aprssig-bounces at lists.tapr.org]
On Behalf Of Wes Johnston
Sent: Thursday, February 24, 2005 7:37 PM
To: aprssig at lists.tapr.org
Subject: [aprssig] agwpe and d700

Can anyone point me to a quick setup guide to get the kenwood d700 working
in
kiss mode with agwpe?  Or advise about the commands to go from TNC PKT on
front
panel to kiss mode on internal TNC?

The NWS office in Columbia SC asked kc4pl and I to help them setup their new
d700 with xastir running on cygwin.  Additionally, they have 2 other voice
radios which are manned by skywarn personnel during activation.  The idea is
to
tap into the headphone/speaker jacks of those two radios and wire them to
the
sound card input on the APRS machine.  This way if one of the skywarn
spotters
sends a mic-e postion over one of the voice repeaters, the aprs PC will hear
it
and it'll be displayed on the map.  So if we run AGWPE with 2 radios hooked
to
the left and right sound card and also the d700, then we can also utilize
the
networking features of AGWPE and offer all packet data to any other PC at
the
NWS office.  I haven't seen a 2m repeater yet that would not pass a mic-e
packet (given that the repeater is already on-air).

Wes.

--






_______________________________________________
aprssig mailing list
aprssig at lists.tapr.org
https://lists.tapr.org/cgi-bin/mailman/listinfo/aprssig