Order Tray | Contact Us | Home | SIG Lists

[aprssig] agwpe and d700

hasan schiers schiers at netins.net
Sat Feb 26 21:50:13 UTC 2005


I believe the command you want is RESTART, not RESET. RESET loads the 
default prom settings, which are not KISS. Telling it KISS ON and RESET is 
basically telling it KISS ON, KISS OFF <g>

...hasan, N0AN
----- Original Message ----- 
From: "Wes Johnston" <aprs at kd4rdb.com>
To: "TAPR APRS Mailing List" <aprssig at lists.tapr.org>
Sent: Saturday, February 26, 2005 3:30 PM
Subject: Re: [aprssig] agwpe and d700


> Ken, today I tried to use the TNC2 template to setup the d700 into kiss 
> mode,
> and it was a no-go.  I used hyperterm to see and interact with the 
> TNC/radio
> and observed that entering KISS ON, and typing RESET did not cause the tnc 
> to
> go into KISS mode - it simple reset and gave the usual TNC2 compatible 
> boot
> screen.  However, entering KISS ON, and cycling the power off and back on 
> did.
> Is there any way to reset the TNC (to finish the kiss mode switch) with 
> out
> having to power cycle the radio?
>
> FWIW to anyone reading this thread, the default TXD is 500mS... holy 
> smokes...
> not even 350ms!!! I'm going to play with mine to see if it'll work near 
> the
> 100mS mark.
>
> Thanks
> Wes
> --
>
>
>
> Quoting Ken Collins <g4fip at tiscali.co.uk>:
>
>> In message <1109291807.421e731f2710c at www.kd4rdb.com>, Wes Johnston
>> <aprs at kd4rdb.com> writes
>> >Can anyone point me to a quick setup guide to get the kenwood d700
>> >working in kiss mode with agwpe?  Or advise about the commands to go
>> >from TNC PKT on front panel to kiss mode on internal TNC?
>>
>> Run AGWPE. This will create a small twin antenna icon in your systray
>>
>> 1.      Click on that icon and select Properties.
>> 2.      Create a New Port and setup the COM port and TNC. Use
>>              the TNC2 option from the TNC selection list. Click on OK.
>> 3.      Click on the systray icon again.
>> 4.      Select Setup Interfaces and enable Winsock TCP/IP Application
>>              Interface with a TCP port of 8000 and click OK.
>>
>> You will now have to exit and restart AGWPE.
>>
>>  From here on, every time you start AGWPE the D700 will automatically go
>> into KISS mode. Conversely when you close AGWPE it will exit KISS mode.
>>
>> Sounds a lot but it is very simple to do and the setup should only take
>> you a couple of minutes.
>>
>>
>> --
>> Ken Collins - G4FIP
>> E-mail:- g4fip at tiscali.co.uk
>>
>> _______________________________________________
>> aprssig mailing list
>> aprssig at lists.tapr.org
>> https://lists.tapr.org/cgi-bin/mailman/listinfo/aprssig
>>
>
>
> _______________________________________________
> aprssig mailing list
> aprssig at lists.tapr.org
> https://lists.tapr.org/cgi-bin/mailman/listinfo/aprssig
> 






More information about the aprssig mailing list