Order Tray | Contact Us | Home | SIG Lists

[aprssig] Out of memory

Keith Kotch kkotch at earthlink.net
Wed Jun 22 12:35:19 UTC 2005


Show us the complete path you have for those 2 files.  That may help
troubleshoot what's wrong.  I suspect it's where you placed those files.

 

Keith, KF4BXT

 

  _____  

From: aprssig-bounces at lists.tapr.org [mailto:aprssig-bounces at lists.tapr.org]
On Behalf Of Sam Guccione
Sent: Sunday, June 19, 2005 11:05 PM
To: TAPR APRS Mailing List
Subject: RE: [aprssig] Out of memory

 

Well I am not sure what is happening but my WinAPRS installation does not
seem to find the config.txt or memory.txt file I created in the WinAPRS
directory because I get the Out of memory message after the station list
gets to 4096 when I have STATIONS in the config file set to 16384.

 

Any ideas on what to try next?

 

Sam K3BY

-----Original Message-----
From: aprssig-bounces at lists.tapr.org
[mailto:aprssig-bounces at lists.tapr.org]On Behalf Of Earl Needham
Sent: Saturday, June 18, 2005 9:43 AM
To: TAPR APRS Mailing List
Subject: Re: [aprssig] Out of memory

At 08:11 AM 6/18/2005, I wrote:




        It's been a while since I ran WinAPRS, but I have a file in my
WinAPRS folder called "memory.txt" and it contains the following:

STATIONS        16382
MESSAGES        16382
PKTBUFFER       2000192
DESTROYICONS    YES

        I'm not really sure these are valid settings, but you might give
them a try.


        I was able to find the following in the WinAPRS documentation: 


memory.txt or config.txt


Either file name can be used. It will look for config.txt first, then look
for memory.txt. Only one will be read. Since users need to be able to
configure the amount of memory being allocated for station lists etc, before
the program is launched and even if they are not registered, a separate
config file is set up for this purpose. It is memory.txt. It must be located
in the same directory as the WinAPRS.exe application. It can contain the
following commands. Use a single TAB to separate the command and the
argument. 

*	STATIONS n - this tells it how many stations to allocate 
*	MESSAGES n - this tells it how many messages to allocate 
*	PKTBUFFER n - how much memory to allocate for the packet buffer
(8192 minimum) 
*	DESTROYICONS YES/NO - this is for WinAPRS ONLY and is to help debug
memory problems. 
*	Version 2.4.0 and 2.4.1 did not destroy icons, version 2.4.2 did.
This will allow users to change the setting so that we can figure out what
works and what does not. 

If the memory.txt file is not present, it will default to the normal station
counts that it did in version 2.4.2. 

        7 3
        Earl



Earl Needham, KD5XB, Clovis, New Mexico DM84jk

http://kd5xb-2.no-ip.info <http://kd5xb-2.no-ip.info/> 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.tapr.org/pipermail/aprssig/attachments/20050622/399b6e9a/attachment.htm 


More information about the aprssig mailing list