[aprssig] Suggested replacement TNC for WIDE digi

[Brad [VE3BSM]]

Thanks for all the replies (including a  couple direct to me).

Coincidentally our big hamfest of the year is tomorrow, so I'll be scouting
for previously enjoyed TNCs, but I'm not hopeful. Failing that, I'll be
monitoring the TNC-X advances with great interest over the next short while.

Brad.
VE3BSM

-----Original Message-----
From: aprssig-bounces at lists.tapr.org [mailto:aprssig-bounces at lists.tapr.org]
On Behalf Of VE7GDH
Sent: Friday, September 02, 2005 8:03 PM
To: aprssig at lists.tapr.org
Subject: Re: [aprssig] Suggested replacement TNC for WIDE digi

Stephen WA8LMF wrote on 02/09/2005

> Currently, unquestionably the CHEAPEST way to get such a digi is give 
> an  old TNC2 clone (MFJ127x,  PacCom, etc) a "brain transplant"
> by replacing it's original firmware with UIdigi firmware.
...
> http://gw.ir3ip.ampr.org/~iw3fqg/uidigi.htm

I couldn't get that URL to load, but this is probably the same content:

www.ir3ip.net/iw3fqg/uidigi-e.htm

I'm looking forward to seeing the TNX-X digi daughter board too.