[aprssig] D7 Band B Monitor

[John Zaruba Jr]

Ron,

I assumed you were using a D700...

If not, please disregard...

73,

John AA2BN


On Sep 29, 2005, at 19:53, John Zaruba Jr wrote:

> Ron,
>
> Your best bet is to utilize the PM memories, since these save the  
> entire radio configuration.
>
> Use P.IN then memory slot 2 to copy the current config to PM2.
>
> Press PM then softkey 2 to get the config you just saved.
>
> Change the Band B VFO to use 144 MHz.
>
> Go into the menu mode for TNC and select Band B as the data band.
>
> Go into the menu mode for APRS and Set Band B as the data band  
> there too.
>
> Now you can use Band A for Airband, VHF HI, etc.
>
> To go back to the old configuration, press PM the softkey 1.
>
> Using PM memories allows you to have up to 5 different radio  
> configurations.
>
> I hope the helped you a bit...
>
> 73,
>
> John AA2BN
>
>
> On Sep 29, 2005, at 19:15, Ron wrote:
>
>
>> Presently I'm using Band A for 144.39 APRS.  Can I use Band  B to  
>> monitor any thing other than 144 to 148.  I would like to set the  
>> Memory or VFO to listen to local air at 120 or public safety at  
>> 154.  The manual isn't clear and I have yet to be successful at  
>> this.  Tnx.
>> Ron
>> WA2WWK
>>
>>
>> _______________________________________________
>> aprssig mailing list
>> aprssig at lists.tapr.org
>> https://lists.tapr.org/cgi-bin/mailman/listinfo/aprssig
>>
>>
>
>
> _______________________________________________
> aprssig mailing list
> aprssig at lists.tapr.org
> https://lists.tapr.org/cgi-bin/mailman/listinfo/aprssig
>