[aprssig] RE: [OZAPRS] Serial Programming Linux

[Andrew Rich]

Hammish.

How do your run this ? 

Do you need to compile it ?

Andy

-----------------------------------------
Andrew Rich
Amateur radio callsign VK4TEC
email: vk4tec at tech-software.net <mailto:vk4tec at tech-software.net> 
web: http://www.tech-software.net
Brisbane AUSTRALIA 



-----Original Message-----
From: Hamish Moffatt [mailto:hamish at cloud.net.au]
Sent: Friday, 25 August 2006 9:16 AM
To: ozaprs at aprs.net.au; TAPR List
Subject: Re: [OZAPRS] Serial Programming Linux


On Fri, Aug 25, 2006 at 07:42:01AM +1000, Andrew Rich wrote:
> Any good at either perl or C programming for serial port routines ?
> 
> I need tx and rx.

It's not hard. Here's an example - it's a program I wrote which emulates
an FT-847's CAT interface.

You pretty much just read from /dev/ttyS0 (Sn). But there are some
special functions to set the baud rate etc.

Hamish
-- 
Hamish Moffatt VK3SB <hamish at debian.org> <hamish at cloud.net.au>