[aprssig] Remote monitoring

[Chuck Kimball]

It uses whatever you have in the the UNPROTO command.

I'm monitoring a couple of solar sites with the KPC3+ 
take a look at http://www.gmra.org/aprs/solar/
(works best with a mozilla browser). 

The graphs are from findu.  

Chuck   n0nhj


----- Original Message ----
From: James Jefferson Jarvis <jj at aprsworld.net>
To: TAPR APRS Mailing List <aprssig at lists.tapr.org>
Sent: Monday, November 6, 2006 4:42:51 PM
Subject: Re: [aprssig] Remote monitoring


Bob wrote:
> No, only comercial TNC that does this is the KPC-3+ and
> KPC-9612+.
> They put out the standard APRS telemetry protocol for 5
> telemetry values.  The format is
> MYCALL>BEACON,PATH:T#SSS,111,222,333,444,555,11111111

Does the KPC-3+ allow you to set a path for the telemetry? I recall that the 
destination address was hard coded to BEACON, and I'm wondering if path is as 
well.

-Jim KB0THN

_______________________________________________
aprssig mailing list
aprssig at lists.tapr.org
https://lists.tapr.org/cgi-bin/mailman/listinfo/aprssig