Order Tray | Contact Us | Home | SIG Lists

[aprssig] Re: Was - Using the D700 without the control head. TS480 will work headless...

Todd gaffit at sbcglobal.net
Fri Aug 24 03:30:32 UTC 2007


----- Original Message ----- 
From: "Steve Noskowicz" 

>    Skimming too fast, I missed that part.   
>    It appears to be the same response you get when you
> disconnect the head while running.  It takes several
> seconds to realize the head is gone and turns off.  
>     It does power up the next time power is applied,
> with ther head connected, with everything as it was
> when the head was disconnected.
> 
>   I do this, and NO I haven't blown it up ... yet.
> 
> 73, Steve, K9DCI
> 
> 
On another note, I was going to go out to the truck and
get the rig and experiment but got to thinking about just
trying my TS480 and see if it would run headless - it does! 

I'm using the Kenwood ARCP480 free program and have
been using it headless for about 20  minutes now and so
far all commands respond...I know this is not the D700, but
thought that I would pass this along. If the 480 can work, 
then most likely the D700 should also, no?  

73, Todd KH2TJ






More information about the aprssig mailing list