[aprssig] Stuck KPC3+ serial port?

[Robert Bruninga]

It could be stuck in Transparent mode or GPS mode.  Hook up
there serial port and enter three ^C's preceeded and folowed by
3 seconds of nothing.  That will get it back to command mode.

Bob
Wb4APR 

> -----Original Message-----
> From: aprssig-bounces at lists.tapr.org 
> [mailto:aprssig-bounces at lists.tapr.org] On Behalf Of Alex
Carver
> Sent: Wednesday, January 24, 2007 6:20 PM
> To: aprssig at lists.tapr.org
> Subject: [aprssig] Stuck KPC3+ serial port?
> 
> Has anyone ever had one of their KPC3+ TNC's get stuck
> as far as communicating with it via the serial port? 
> It's set up as a digipeater right now and is working
> just fine but I can't seem to connect to it.  This
> problem only recently cropped up but I didn't do
> anything special to the TNC (as far as I know).  It is
> unresponsive to both Hyperterm and Minicom.  The cable
> does work as I unplugged it from a working KAM98.
> 
> I've restarted the KPC3+ several times though I
> haven't used the factory reset pins (I was hoping to
> avoid that so I wouldn't have to reprogram the whole thing).
> 
> 
>  
> ______________________________________________________________
> ______________________
> Don't pick lemons.
> See all the new 2007 cars at Yahoo! Autos.
> http://autos.yahoo.com/new_cars.html 
> 
> _______________________________________________
> aprssig mailing list
> aprssig at lists.tapr.org
> https://lists.tapr.org/cgi-bin/mailman/listinfo/aprssig
>