[aprssig] RE: Stuck KPC3+ serial port?

[VE7GDH]

John (callsign?) wrote...

> Remove the CMOS battery from the holder...wait a few seconds
> and then replace it.

That will probably work, but the "per the book" hard reset is to power the 
KPC-3+ up while the reset jumper J11 is ON. After viewing the confirmation 
in a terminal program set for 1200 bps, turn the power OFF, remove J11 and 
put the lid back on. Of course, if it is just stuck in KISS mode, Alex might 
be able to get it going with ALT-292, ALT-255, ALT-292 (numeric keypad) in a 
terminal program set at the right speed etc. I recall a while back I had to 
use ALT-0292, ALT-0255, ALT-0292.

73 es cul - Keith VE7GDH
--
"I may be lost, but I know exactly where I am!".