[aprssig] MT1200 Tracker Setup

[Ron Wenig]

Thanks Jerome,

I'm guessing GPATH would be set as GPATH GPS3/ VIA WIDE1-1,WIDE2-1 it would
give me a symbol of a 3 in a circle.  That would be the same as the LTP
command.

73, Ron ny3j
  -----Original Message-----
  From: aprssig-bounces at lists.tapr.org
[mailto:aprssig-bounces at lists.tapr.org]On Behalf Of J T
  Sent: Friday, August 22, 2008 11:56 AM
  To: TAPR APRS Mailing List
  Subject: Re: [aprssig] MT1200 Tracker Setup


        Refer to the GBEACON, GTEXT, GPATH commands in the manual which is
available at: http://www.kantronics.com/products/mt1200.html

        -Jerome, W0JRT

        --- On Fri, 8/22/08, Stephen H. Smith <wa8lmf2 at aol.com> wrote:

          Ron Wenig wrote:

> Hi All,>> I am helping a friend configure a Kantronics MT1200G to use as a
tracker.> It looks similar in programming to a KPC3+ but it doesn't have
thesame GPS> beacon commands.  Does anyone have any experience with the
MT1200 in> particular how to set it up as a tracker.  I can't find too
muchinformation> out there so it doesn't look like a lot of people are using
this modelfor> Amateur radio projects.>> 73, Ron
 ny3j

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.tapr.org/pipermail/aprssig/attachments/20080822/65cff553/attachment.htm