[aprssig] Kenwood D-700?
Kai Gunter Brandt
kai.brandt at hjemme.no
Sat Jun 21 02:28:50 CDT 2008
Jan T. Pharo skrev:
> AC7YY - Kim <ac7yy at comcast.net>, Fri, 20 Jun 2008 14:04:00 -0700
>> Is there a Power "On" and a Power "Off" command available while
>> in PKT mode?
> I thought that the power on/off button on the front panel would work
> even in PKT mode.
You can issue the command off to get the following result:
"The TNC is not on, and the radio will not send/receive data over the
air. Note that in this mode the radio will still accept control
commands over the serial port."
The command to send is "AI 0"
You probably have to send CTRL+C if the TNC is in CONVERSE mode before
sending the "AI 0"
But theres no "Power Off" but you can send the commands:
TOT 0 (set auto power off to 3min [the lowest value])
APO 1,0 (Turn on AutoPowerOff)
More information about the aprssig