[aprssig] Xastir Internet->RF configuration
tim_cunningham at charter.net
Tue Apr 7 15:03:12 CDT 2009
Just for clarification. TXDelay is a parameter that has an impact on both
ends of the link. It is not simply something that is set to see how fast
your radio can lock on frequency and come up to power. There are
ramifications on the receive end as well.
While you may be able to set TXDelay less than 100ms, it does not mean
everybody can decode it. For users who still use a squelch circuit ahead of
their audio tap, you must allow enough time for the squelch to open the
audio path before data can pass for decoding.
The real question may be how slow is the slowest squelch circuit on your
Tim - N8DEU
----- Original Message -----
From: "Keith VE7GDH" <ve7gdh at rac.ca>
To: "TAPR APRS Mailing List" <aprssig at tapr.org>
Sent: Tuesday, April 07, 2009 1:56 PM
Subject: Re: [aprssig] Xastir Internet->RF configuration
> Curt WE7U wrote...
>> I'm using the "Serial KISS TNC" interface and have "40" entered for
>> TXDelay (400 ms), but for my KISS TNC it doesn't matter as it's set with
>> a pot on the TNC (TNC-X).
>> I usually set it between 25 and 40, depending on the radio. With
>> different TNC's than this one of course.
> I realize you are using the TNC-X where the TXDelay is set with a pot, but
> for anyone using another TNC where it is set in software, 250 to 400 ms is
> usually much longer than needed. I have reliably used less than 100 ms,
> regularly use 100 ms and suggest about 125-150 ms for someone that doesn't
> want to take the time to see if shorter TXDelay can be used. Yes, if it's
> too short, no-one will be able to decode your tones, but set too long, and
> it uses up valuable bandwidth.
> 73 es cul - Keith VE7GDH
> "I may be lost, but I know exactly where I am!"
> aprssig mailing list
> aprssig at tapr.org
More information about the aprssig