[aprssig] UI-VIEW setup

[Keith VE7GDH]

Andrew VK4TEC wrote...

> I am trying to configure UI-View to go from RF to INET
>
> That is no probs

OK, but if it isn't a problem... ?

> It is the "pass only messaging" I am having probs with.
>
> I can set "VK4* = DEST"...

I'm sure there are lots of knowledgeable users here, but you might get
more responses on the UI-View support list, but why don't you state what
you are trying to do? You said above "trying to configure UI-View to go
from RF to INET"... are you trying to gate messages to local stations,
or perhaps gate a particular station to RF? If you are just trying to
gate messages to local stations, why message around with messages to
VK4* stations? I can give you all kinds of suggestions on how to do
that, but before I invest time in that, I'll await a confirmation that
this is what you are trying to accomplish.

You weren't trying to gate ALL message to VK4 stations to RF, were you?
I have no idea how much messaging goes on in VK land and whether it
would create enough traffic to inundate the RF network around you.
Perhaps you are just trying to gate messages to local stations.

>  but once you use up "VK4*" you can't re-use that in the UI-View list
>
> Ideas ?

What UI-View list? I kinda suspect you are just trying to gate messages
to local stations, but perhaps you could say. Sorry, but if you ask a 
vague question, you will likely get a vague answer... or none at all.

73 es cul - Keith VE7GDH
--
"I may be lost, but I know exactly where I am!"