[aprssig] Digipeater Hick-up - KPC3+ Goes Deaf?
Wes Johnston, AI4PX
wes at ai4px.com
Tue Jul 28 10:59:12 CDT 2009
I had a 5v supply fail in a kpc3 once and "nearly" cook the microprocessor.
I say nearly because it booted and ran fine except that it would not decode
packets with CD INT mode. Instead I had to use the default of squelch CD
which stinks for digipeater use. Granted this was probably a once in a
lifetime failure mode, but if you are not digipeating anything at all, it
could be your problem.
Hitler gave great speeches too!
On Tue, Jul 28, 2009 at 06:46, Mr Jeffrey L Ross
<radiooperator at comcast.net>wrote:
> hi, make sure you set the recv. lite on the tnc with the squlz. if you can
> not get it to work, then set your cd command to software or internal,
> whatever one it is not on then try it. set your vol. to low but not off.
> good luck
> aprssig mailing list
> aprssig at tapr.org
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the aprssig