[aprssig] UI-VIEW tcp/ip only question

[Rusty Bryant]

explain the "populated" statement.

no path entered defaults to a path of APRS.  



--- On Fri, 6/5/09, Andrew Rich <vk4tec at tech-software.net> wrote:

From: Andrew Rich <vk4tec at tech-software.net>
Subject: Re: [aprssig] UI-VIEW tcp/ip only question
To: "TAPR APRS Mailing List" <aprssig at tapr.org>
Date: Friday, June 5, 2009, 11:17 AM



 
 

Make sure your callsign and passcode are 
populated.
 
Set your internet tx time to 60 
minutes.
 
There should be no path
 
 

  ----- Original Message ----- 
  From: 
  Rusty Bryant 
  
  To: TAPR APRS Mailing List 
  Sent: Saturday, June 06, 2009 1:06 
  AM
  Subject: [aprssig] UI-VIEW tcp/ip only 
  question
  

  
    
    
      All,

I am currently away from my home station 
        where I run UI-VIEW 32.  I do have it installed on my laptop which 
        I have with me.  I am connected to an aprs server and am receiving 
        packets, however I am not able to transmit packets back through the 
        internet.  I have no radio attached and just want to be able to 
        transmit over the internet.  What should my unproto path be to 
        allow for this?

I'm sure its a simple answer but i can't figure 
        it 
  out...

thanks

Rusty
WB4BSD


  
  

  _______________________________________________
aprssig mailing 
  list
aprssig at tapr.org
https://www.tapr.org/cgi-bin/mailman/listinfo/aprssig

  
  

  
No virus found in this incoming message.
Checked by AVG - 
  www.avg.com 
Version: 8.5.339 / Virus Database: 270.12.53/2155 - Release 
  Date: 06/04/09 17:55:00

-----Inline Attachment Follows-----

_______________________________________________
aprssig mailing list
aprssig at tapr.org
https://www.tapr.org/cgi-bin/mailman/listinfo/aprssig



      
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.tapr.org/pipermail/aprssig/attachments/20090605/6915b758/attachment.htm>