Order Tray | Contact Us | Home | SIG Lists

[aprssig] temporary APRS setup

Steven Brower stevenbrower at verizon.net
Sun Nov 1 13:54:37 UTC 2009


Thanks, Mark
That's true about the power on that thing- I put it in my freezer for an hour and the power did go down a bit but less than a volt. I will have to retest with all the new electronics I've subsequently come up with for the payload.  It's so tiny though.  I guess an Alinco is the more typical choice, even though its heavier.  I found a digipeater 100 miles away from my launch site and I am thinking that's too far to depend on for the returning payload.  Do you have suggestions about a temporary digi/igate to supplement that distant station?  How much coverage would one need at a minimum?  Again, this is out in Montana, north of Livingston.
Steven Brower
KC2SQU


Mark's reply:
I would hesitate to use the VX-1 as the RF source. This radio is nice, 
but if it has a low battery or power interuption, a button press is 
required on the power button to set things right again - so you would 
lose positions. It also in my tests didn't do well in ground-level cold 
temps (20F range). At altitude, your balloon electonics could be colder. 
Have you simulated a flight to see if your battery set-up can run the 
package for the full duration predicted, and then some?
-- 
      ) )    de WA2MCT Mark
     ( (     Echolink   221408    Grid Square EL17HQ
      ) )    You will be assimilated... oooh, coffee!!
   _|****|   http://www.findu.com/cgi-bin/find.cgi?wa2mct-7 Home
  ( |    |   http://www.findu.com/cgi-bin/find.cgi?call=wa2mct-9 Mobile
   `|____|   wa2mct at mearle.com  wa2mct at juno.com




More information about the aprssig mailing list