[aprssig] Kenwood D700A Control Head Brackets
wa4ikq at nevets.oau.org
Thu Mar 18 08:06:38 CDT 2010
It is very easy to make a custom bracket from a piece of sheet metal,
aluminum, i.e., cut to a slightly smaller width than the slot on the
rear of the control head. One can make the bracket to any length,
bend it, drill it, and spray paint it flat black to finish it.
I found this preferrable to using the original hardware supplied
with the radio.
Date: Wed, 17 Mar 2010 20:58:40 -0600
From: "Joel Maslak (N7XUC)" <jmaslak-aprs at antelope.net>
Subject: [aprssig] Kenwood D700A Control Head Brackets
Does anyone have a good source to get a D700A control head bracket? I've
lost my original bracket and am looking for a replacement.
More information about the aprssig