[aprssig] Remote programming a KPC3+ via RF

[Clay Melhorn]

First of all,
Thanks to Ralph and Neville for your response.
I have some reading to do on the MFJ-1278 tnc as it does not have dip switches to set baud rates and the like
but the mfj-1278 works fine in UIView so KISS mode works apparently,
>>but as Neville sugests it will not go from command to talk automatically.<<
That is the problem.
One big red flag went up, I found that mycall had reverted to NOCALL on the mfj-1278, hmmm...
Looks like everything must have reset to default.
 
I got PO'd and pulled out my good old PK-80 with the MFJ tnc-2 chip in it, worked like a champ!
 
Thanks again for responding guys, I appreciate the help.
 
Now, next question is are there any mfj-1278 guys here that can explain why it's stuck in command mode?
 
Thanks again in advance.
73'
 
Clay N9IO
 
 
> My first guess will be the parameter on the TNC for automatially
> change from command to talk mode. Then I will go to check on monitor
> parameters. I assume you can blame those if you don't see response
> from the remote station. I use most Kantronics, so I am not familiar
> with MFJ commands.
> Hope my ideas may help you.
> 
> 
> 
> -- 
> Neville
> https://fedoraproject.org/wiki/User:Yn1v
> Linux User # 473217
> 
> - - - - - - - - - - - - - - - - - - - - - - - - - - - -
> Check: http://www.clickmanagua.com
> - - - - - - - - - - - - - - - - - - - - - - - - - - - -
> 
> _______________________________________________
> aprssig mailing list
> aprssig at tapr.org
> https://www.tapr.org/cgi-bin/mailman/listinfo/aprssig
 		 	   		  
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.tapr.org/pipermail/aprssig/attachments/20101102/20d83367/attachment.htm>