Order Tray | Contact Us | Home | SIG Lists

[aprssig] Linking digipeaters

Fredric Moses fred at moses.bz
Mon Mar 7 16:02:37 UTC 2011


I second APRX.  We have it running on a few sites here in michigan and on our Southfield site it runs VHF and UHF ports.  We have it setup to gate UHF packets to VHF... but only gate 2 way messages back the other way if need be... UHF is like an alt input as well as special use.

APRX also spits out channel telemetry for each of it's radio ports. http://aprs.fi/telemetry/a/SFLDV

Hardware wise I have it running on a cheap linksys router.  Which has 2 serial ports on it as well.  I also had it running on a WRAP1C board.. but figured the linksys routers where cheaper to buy in bulk on craigslist.


--
Fredric Moses - W8FSM
fred at moses.bz



On Mar 7, 2011, at 9:56 AM, la3qma at aprs.la wrote:

> Quoting "Wes Johnston, AI4PX" <wes at ai4px.com>:
> 
> 
>> It sure would be nice if we had a multiport KISS controller that would take
>> KISS frames from multiple TNCs, perform the digipeating functions and spit
>> the modified KISS frames back out the same or different ports.
>> 
>> I think digined would do this, but it runs on a DOS pc.  I'm thinking more
>> along the lines of something running on a small processor such that the TT4
>> and T2s are based on.  Most of these simple KISS devices don't use flow
>> control, so the device would have ot be able to buffer a couple of packets
>> from each port at a time.  It'd probably require a real hardware UART.
>> 
>> Any ideas?
>> 
> 
> Maybe you can use APRX ??
> 
> http://wiki.ham.fi/Aprx.en
> 
> 
> This software can use multiple radios and you can divide them by "interfaces" so each of them have different rule sets.
> You can do cross band etc.
> 
> Kai Günter
> LA3QMA
> 
> _______________________________________________
> aprssig mailing list
> aprssig at tapr.org
> https://www.tapr.org/cgi-bin/mailman/listinfo/aprssig




More information about the aprssig mailing list