[aprssig] KPC3+ induced errors

[Andrew Rich]

Is it a genuine delay?

Are packets lost ?

Is it a flow control issue ?

Does the test setup use no flow control ?

- Andrew -

----- Original Message ----- 
From: "Bill Herrmann" <bherrman at spro.net>
To: "TAPR APRS Mailing List" <aprssig at tapr.org>
Sent: Sunday, March 27, 2011 4:28 PM
Subject: Re: [aprssig] KPC3+ induced errors


> At 02:54 PM 3/15/2011, Stephen H. Smith wrote:
>>The problem appears after several hours or day running in KISS mode 
>>and shows up as RECEIVED packets being held for long periods (up to 
>>several minutes at
> 
> This is an important note and anyone reporting the problem to 
> Kantronics should be sure to stress that it is a delay of the 
> received packets. I'd thought from following the messages that it was 
> on the transmit side. (I don't generally run KISS so I haven't seen 
> it other than on the trying to diagnose remotely.)
> 
> Just a thought, but can any of the stations that are managing to 
> reproduce the problem capture RX audio? (perhaps with a digital 
> recorder) If someone can capture a stream of audio that reproduces 
> the problem it would be much easier for Kantronics to fix the 
> problem. (and harder to deny it exists)
> 
> Bill 
> 
> 
> _______________________________________________
> aprssig mailing list
> aprssig at tapr.org
> https://www.tapr.org/cgi-bin/mailman/listinfo/aprssig