[aprssig] BRRRAAAPS and listening

Lloyd Mitchell lloyd at mitchell-web.net
Fri Oct 21 09:33:17 CDT 2011

Bob, You make me laugh....this reminds me of the admiral that wanted a
piece of wire one nanosecond long...

Gye Nyame 

-------- Original Message --------
Subject: [aprssig] BRRRAAAPS and listening
From: "Bob Bruninga" <bruninga at usna.edu>
Date: Fri, October 21, 2011 10:27 am
To: "'TAPR APRS Mailing List'" <aprssig at tapr.org>
Cc: APRS at yahoogroups.com

Sometimes I get the feeling that few people listen to the APRS channel
and then to hear what is going on. There is a lot to be learned just by

For example.. If you hear


You are hearing a 50% wasted channel, because all the BRRRRRR's at the
beginning are just TXD delay. The AAAAAP on the end is the actual APRS
data. The data in an APRS Mic-E packet lasts typically 1/2 second. If
TXD is 500 ms, then channel capacity in THAT ENTIRE AREA is suffering a
loss in channel capacity.

Typically, we can operate with TXD's of about 150 ms. PLEASE everyone,
listen in your area and fix any digipeater that is blathering all this
wasted bandwidth!

This also applies to your own station. Kenwoods used to come with a
of 500ms which was unbelievably long. Please check your settings and
permanently re-configure to 200 or 150 ms.

A packet should sound more like:


But the most important setting is the DIGIPEATERS! Because they impact
EVERY SINGLE PACKET in the area. Fixing them with minimum TXD can have a
nearly doubling of channel capacity. Fixing one LID's mobile setting is
only going to change the area load by 1%...

FIX THE DIGIS. And also make sure they are providing the local area
repeater frequency object in the local area as well while you have the
SYSOPS attention...


aprssig mailing list
aprssig at tapr.org

More information about the aprssig mailing list