[aprssig] 12V wiring ideas

[Randy Allen]

Actually, ,I was able to do that with my RigRunner 4005. There was just 
enough clearance to run a small wire tie through the roll pin hole on 
the chassis mounted APPs so I could wire tie the outgoing lines to them.

Very tedious and took some patience.

Don't know if mine was just a fluke on my particular box or if it was 
model specific.  You can't really see the roll pin holes on the online 
pictures.

Outgoing lines feed my TM-D700 and StreetPilot GPS (Just to keep it APRS 
related ;-) )

73

Randy KAØAZS

On 10/29/2011 19:24, Bob Burns W9RXR wrote:
> Ty-wraps or clips may work fine in an in-line connection
> between two cables, but I haven't seen a PowerPole fuse block from West
> Mountain Radio, PowerWerx, or Saratoga that would allow you to snake a
> ty-wrap around the connector in the fuse block to keep the mating
> connector from pulling out of the fuse block.
>
> Bob...