[aprssig] KPC9612+ APRS RFI

[Stephen H. Smith]

On 8/12/2012 2:05 PM, Rory Bowers, K6CKS wrote:
> I just tried to set up my KPC9612+ for APRS operation on 144.390 Mhz here in
> Western Arkansas.  I was surprised to find the frequency on my Icom radio
> jammed out by digital noise being generated by the TNC.  I powered up my KPC3
> and did not have the same problem but as soon as I powered up the 9612+ the
> noise was back. Has this been addressed by Kantronics?
>
Most likely NO.  The 9612 is an discontinued product.

How far from the antenna is the 9612?     It should be fairly easy to choke off 
the noise since the only leads into and out-of this device are power, serial 
cable to PC and TX/RX audio to radio.


-------------------------------------------------------------------------------

--

Stephen H. Smith    wa8lmf (at) aol.com
EchoLink Node:      14400    [Think bottom of the 2M band]
Home Page:          http://wa8lmf.com  --OR--   http://wa8lmf.net


Mobile SSTV LiveCAM!
    http://wa8lmf.net/mobile
    http://wa8lmf.net/ham

*** NEW ***  HF APRS Using PSK63
   http://wa8lmf.net/APRS_PSK63/index.htm

JavAPRS Filter Port 14580 Guide
   http://wa8lmf.net/aprs/JAVaprsFilters.htm

"APRS 101"  Explanation of APRS Path Selection & Digipeating
   http://wa8lmf.net/DigiPaths

Updated "Rev H" APRS            http://wa8lmf.net/aprs
Symbols Set for UI-View,
UIpoint and APRSplus: