[aprssig] Bulletin ID - Kenwood Problem?
gm1wkr at gmail.com
Tue Dec 17 12:25:42 CST 2013
I'm sending solar indices using BLN9 ...
:BLN9 :Solar SFI:168 SPD:408.2 DEN:3.5. GeoMag Ap:4 Kp:2 Bt:1.8 Bz:1.6
The 9 is static so that the BLN takes the same place in the receiver
display. APRSIS32 shows the following ...
22:36:14 MB7UZ::9 Solar SFI:168 SPD:408.2 DEN:3.5. GeoMag Ap:4 Kp:2 Bt:1.8
As expected (from Lynn's previous explanation) APRSIS updates the payload
and time received without creating a new line - the old info is
updated. The Kenwood D710, however, creates a new line in the message
screen for each packet (each with BLN ID 9). This just fills up the
message screen with what looks like new messages.
Can anyone see if there is anything in my generated packet that is causing
this or is it simply a Kenwood issue? I am quite sure this worked as
expected previously (while working on the script).
,WIDE1-1,qAR,MB7UAB::BLN9 :Solar SFI:154 SPD:406.1 DEN:2.5. GeoMag
Ap:7 Kp:0 Bt:4.0 Bz:-3.2
Many thanks and 73,
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the aprssig