[aprssig] What is the process to make changes to APRS symbols document ?

Tom Hayward esarfl at gmail.com
Wed Sep 9 20:13:44 CDT 2015


On Wed, Sep 9, 2015 at 6:02 PM, Tom <tom.w1tg at yahoo.com> wrote:
> Hi Tom,
>
> I can't seem to get my point across.  I'm not trying to gate or pass this traffic via a TNC.  This doesn't have anything to do with the filter I'm using and I'm not hearing the DStar stations via RF on my gateway.

I could have sworn you referred to your "igate". By definition, that
is a gateway between APRS-IS and RF with a TNC. You can understand my
confusion if this is not what you meant by "igate".

> I guess you may have to run an APRS Client and watch the tcpip traffic being fed to it by the client connection to the server.
>
> DStar traffic is not being sent back to the connected APRS CLient by default from the connection to APRS IS.  By default prior to the update the DStar stations and positions would display on the APRS Client.  Now it doesn't after the update.

By default, only messages will be sent on a filter port. We've already
established that you are using a specific filter, so the default case
is no longer applicable. There'd be a lot less back-and-forth if you
could just say "using this filter ____, I'm not receiving this station
____".

> Who writes the software?

Hes wrote this software. Refer to previous message of mine with link
to software change list and source code.

Tom KD7LXL


More information about the aprssig mailing list