[aprssig] OT:: Jeep and Radio
Fred Hillhouse Jr
fmhillhouse at comcast.net
Wed Sep 16 14:31:24 CDT 2015
>From previous experience of antenna on moving parts, (e.g., trunk lids,
hoods) I would recommend not mounting on the spare tire carrier. I used to
use the lip mounts for antennas and found my wife and other family members
opening and closing the trunk quickly. Of course you are mounting on a
vehicle you may take into the boonies so a study mount and antenna will se
more stress from the road than opening and closely the carrier.
One thought I had is to mount on the roll cage and put a hole in the
fiberglass. A rubber boot like a CV joint boot could be used as the pass
through. I have never picked up a Jeep to test the theory.
One other thought, use a ¼ wave for the in close work and carry a 5/8 or
whatever when stopped. A couple of guys in my area have a Land Rover and
they have a rack inside for carrying their antennas.
PS. For your researching pleasure:
From: aprssig [mailto:aprssig-bounces at tapr.org] On Behalf Of Nagi
Punyamurthula via aprssig
Sent: Saturday, September 12, 2015 11:32 AM
To: aprssig at tapr.org
Subject: [aprssig] OT:: Jeep and Radio
I had recently acquired a Jeep and exploring installing my Kenwood d710g in
it. Mstly for APRS and voice repeaters on 2m/70cm
Wanted to see if folks here have any jeep install pictures you might be able
to share for ideas.
The bracket I'm zoning in on is at extremeterrain website
While this is meant for CB, I think it can be made to work for 259s
Sent from my Windows Phone
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the aprssig