[aprssig] IGATE message routing bug?
bruninga at usna.edu
Fri Jul 15 09:27:04 CDT 2016
In preparation for the Golden Packet event, a few of us noticed that we
were not getting ANY messages into or out of the ANSRVR or CQSRVR.
Turns out, the local IGates or APRS-IS were not recognizing our stations
(as being local) until/unless the message station first sent a position
Please confirm that this is not a huge bug in APRS-IS behavior that does
not recognize an APRS station (in the IGate/APRS-IS system) unless and ONLY
IF it sends a valid position report. This is not how APRS messaging is
supposed to work. There should not be any dependence on a position report
for 2-way messageing to work.
Is it the failure of some local IGates or is it some kind of filtering
issue in the APRS-IS.
Where do we fix this?
*From:* at-golden-packet at yahoogroups.com [mailto:
at-golden-packet at yahoogroups.com]
*Sent:* Thursday, July 14, 2016 1:09 PM
*Subject:* [at-golden-packet] ANSRVR Acks and Replies
I was not receiving acks or replies from ANSRVR to WJ3K-5, even though I
saw them on aprs.fi. It was re-sending ANSRVR messages five times - not
good. No replies were coming back to and through my WJ3K-10 IGate running
I checked the list of registered stations on the IGate, and WJ3K-5 was not
there. As soon as I sent a position packet from WJ3K-5, it was registered,
and the IGate WJ3K-10 began to return replies and acks.
Lesson learned: To receive messages, replies and acks from ANSRVR (or any
other station through APRSIS), first transmit a position packet over the
same digipath. As long as it hits an IGate, you should be good to go.
Comments or questions?
- Gordon Davids / WJ3K
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the aprssig