[aprssig] 2 Port Digitpeater was: APRS UHF freq? (9600 baud)
scott at opentrac.org
Wed Jan 25 11:08:53 CST 2017
My multi-port gadget is making progress, too. Right now my focus is on
the repeater controller version as a follow-on to the ADS-SR2, but the
same hardware will work equally well as a dual-port digipeater. The
next hardware revision will have a third input-only port for a dedicated
I also just got a BASIC interpreter running on it that will replace the
Tracker2/Tracker3 series' funky bytecode interpreted scripting system.
It's not as powerful as a Raspberry Pi but it boots in half a second and
draws less power.
On 1/25/2017 8:40 AM, John Langner WB2OSZ wrote:
>> Has anybody actually succeeded in putting two KISS TNC's "back to
>> back" to form an independently operating (no computer between them)
>> two-way "bridge" to pass traffic bi-directionally?
>> Lots of suggesting that this could work, but has it been done?
> In theory it should work but it's not a proper solution to the problem.
> Here is why.
> When a packet is first transmitted, the via path contains information on how
> it might be forwarded by digipeaters.
> Each time a digipeater retransmits a packet, it modifies the via path to
> decrease the number of possible remaining digipeater hops. This limits the
> number of times it can be retransmitted.
> If you were to simply retransmit what you hear on one frequency onto some
> other frequency, that would be OK if only one person was doing it. However,
> if you had two stations like this, that could hear each other, the same
> packet could go bouncing back and forth forever.
> To do it properly you would want to put an application between the two TNCs
> to perform digipeating by the normal rules. There are countless digipeater
> implementations out there but I'm not sure how many of them can handle
> multiple radio channels at the same time.
> The "direwolf" software TNC can handle up to 6 radios at the same time and
> has the ability to digipeat between different channels in any combination.
> Run it on a Raspberry Pi and you have something smaller and cheaper than a
> stack of old TNCs, with better receive decoding, and vastly more
> aprssig mailing list
> aprssig at tapr.org
More information about the aprssig