[hfsig] Sidebands on Raspberry Pi WSPR carrier

Zoltan Doczi zoltan.doczi at gmail.com
Mon Sep 5 11:14:40 CDT 2016


Hi Ron,

You might also give a try to run RPi from WiFi connection instead of
ethernet or simply remove ethernet connector for shake of testing momentary.

73,
HA7DCD
Zoltan

On Mon, Sep 5, 2016 at 6:08 PM, Ron Ott <ronott at sbcglobal.net> wrote:

>
> Last night I completed some revealing tests with the Raspberry Pi (=RPi)
> TX with TAPR 20m WSPR kit.  *The bottom line is that grounds are the
> cause of the observed spurious sidebands.*
>
> * I see no sidebands when the TX is connected to a 50-ohm load and my HP
> scope with a *floating ground *input.  I'm receiving on an SDR with an
> outside 20m vertical antenna, picking up stray RF.  In this setup the RPi
> TX is fully isolated from any grounds in the shack.
>
> * When I move the 50-ohm load to the input of an HP frequency counter with
> a grounded-shield (1Mohm) input, I see several sidebands on the carrier
> that are multiples of 60Hz. In this setup the shield side of the RF output
> coax is connected to the mains ground through the frequency counter.  I
> decoded four (4) WSPR signals simultaneously - the carrier and three of the
> sidebands.
>
> * I played with ground leads to the RPi USB connector shells and to the
> ground side of the RF output terminal strip, but there was no change in the
> sidebands.  Since the RPi is a small computer, the grounds are not that
> easy to discern and it may take some experimenting to discover what works.
>
> ** Potential solutions*: Perhaps running the antenna lead directly to the
> transmitter without a ground connection in the shack might help - an
> experiment for tomorrow.  An un/un transformer might be used to isolate the
> RPi grounds from the shack ground and avoid the ground loops.  I'll look
> into making an un-un myself or buying a commercially built one from Balun
> Designs.
>
>
> Ron, W6XY
>
>
> _______________________________________________
> hfsig mailing list
> hfsig at tapr.org
> http://www.tapr.org/mailman/listinfo/hfsig
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.tapr.org/pipermail/hfsig/attachments/20160905/11437be6/attachment.html>


More information about the hfsig mailing list