[hfsig] Fw: Sidebands on Raspberry Pi WSPR carrier - how much does a homebrew 1:1 balun help?

Ron Ott ronott at sbcglobal.net
Fri Sep 9 18:15:19 CDT 2016


Update:  I wound a second balun with 11.5 turns of #30 insulated wire and was more careful about the bifilar windings, starting both the primary and secondary at the same point on the Amidon toroid. In addition, I potted the wound toroid with common epoxy.  The measured insertion loss decreased to 0.55dB at 14.1MHz.  The signal looks great on the WSJT-X waterfall display, I don't see any sidebands and I'm not getting double spots now, even with a strong signal in the receiver.
Ron, W6XY

     
----- Forwarded Message -----
 From: Ron Ott <ronott at sbcglobal.net>
 To: TAPR HF Modes SIG Mailing List <hfsig at tapr.org> 
 Sent: Wednesday, September 7, 2016 7:14 PM
 Subject: [hfsig] Sidebands on Raspberry Pi WSPR carrier - how much does a homebrew 1:1 balun help?
   

Construction:  I received the parts to make a 1:1 balun this afternoon and wound 5 turns each of #30 insulated wire for the primary and secondary on an Amidon FT 37-75 toroid core.  The primary and secondary windings are bifilar wound (interleaved) around the toroid with leads coming from opposite sides of the "O".  The balun is installed in a small plastic box with BNC connectors on each end, no potting or glue was used.
Insertion loss: I measured 1dB loss at 14MHz when the balun was inserted in a coaxial line from my HP signal generator and terminated in 50ohms; with some experimentation, this loss could probably be reduced as I just guessed at the number of turns based on the AMRAD design for a LF balun.  As a result, my ERP will decrease from 18dBm to 17dBm.
Effect on sidebands due to AC modulation:  Listening to myself on the air on 20m while transmitting with the Raspberry Pi, I still get occasional double spots due to a sideband 120Hz from the carrier frequency. However, the difference betwen the carrier and sideband signal strengths can be over 50 dB with the balun, according to WSJT-X, making the RPi WSPR transmitter apparently within FCC specs for spurious transmissions.
Looks like this is a worthwhile addition to the RPi TAPR kit setup and helps reduce the sidebands 10s of dB, at least at my station.
73, Ron




_______________________________________________
hfsig mailing list
hfsig at tapr.org
http://www.tapr.org/mailman/listinfo/hfsig


   
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.tapr.org/pipermail/hfsig/attachments/20160909/6613e6b2/attachment.html>


More information about the hfsig mailing list