[hfsig] Problem with operation

Richard Waller rewaller at verizon.net
Mon Mar 27 17:54:59 CDT 2017


Todd, I'm a noob too but you need to type sudo ./wspr then the rest of it starting with -r. Also make sure you are in the WsprryPi directory 

Sent from my iPad

> On Mar 27, 2017, at 1:45 PM, todd <nexstar1 at hughes.net> wrote:
> 
> Received my wspr board and installed it in a Raspberry Pi 3B board(no problem here).
> Went through the latest install instructions in which everything seemed ok.
> I then typed this in:
> wspr  -r -o -s wd6dfh CN84ke 20 20m    enter
>  
> and I get this message   can't open /dev/mem
> Then it just stops. Did this not get installed when I set it up or does it have to be set up after the install? Am a rank noob when it comes to Linux.
>  
> If I use the old way:
> sudo ./wspr -r -o -s wd6dfh CN84ke 20 20m
>  
> the screen locks up and the power to the Raspberry has to be removed to re-boot.
>  
> Any help would be much appreciated.
>  
> Thanks
> Todd  WD6DFH
> _______________________________________________
> hfsig mailing list
> hfsig at tapr.org
> http://www.tapr.org/mailman/listinfo/hfsig
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.tapr.org/pipermail/hfsig/attachments/20170327/a73c8117/attachment-0001.html>


More information about the hfsig mailing list