[time-freq] TADD-1 JP3 termination

[John Ackermann N8UR]

If you're terminating the input signal into the TADD-1, then you would 
want to install JP3 to provide a 50 ohm load.  The unjumpered setting is 
for daisy-chaining multiple loads, or where the source is high impedance.

John
----

Trevor Smithers wrote:
> Have just completed the TADD-1 and I'm a bit confused as to what to do with JP3 - leave open 
> or short with the header.
> 
> The intention is to use the 50R output from a Thunderbolt as the input to TADD-1
> 
> Trevor  G0KTN
> 
> _______________________________________________
> time-freq mailing list
> time-freq at tapr.org
> https://www.tapr.org/cgi-bin/mailman/listinfo/time-freq