FW: [wxsig] Still looking for solution :-(

[Will Beals]

Email from Bill being forwarded to the sig, I'll reply to the second one.

will 

-----Original Message-----
From: Bill Hosking [mailto:hoskingb at earthlink.net] 
Sent: Sunday, November 19, 2006 10:22 PM
To: will at beals5.com
Subject: Re: [wxsig] Still looking for solution :-(

No problem - see below
----- Original Message -----
From: "Will Beals" <will at beals5.com>
To: "'Bill Hosking'" <hoskingb at earthlink.net>
Sent: Sunday, November 19, 2006 2:55 PM
Subject: RE: [wxsig] Still looking for solution :-(


> Bill:
>
> I had some other questions too that would help, do you mind answering to 
> the
> reflector?  They are below again.
>
> will
> ---------------------
> On the lockup, a few more questions:
>  Does the LED continue flashing? No, it does not

>  I understand you do not have a TNC, but which TNC mode is selected?

>  Can you hit the menu button to get back to menus or do you have to hit
> reset? I have to Reset

>  Can you measure the 1-wire bus voltage with a volt-meter with and without
> the humidity sensor attached?  If possible, read it with the T238 hung 
> too.
> While running, the bus voltage will vary on a voltmeter, so max value is 
> OK.
>
>Not without running up on roof and pulling the option jumper - 
>unfortunately we have
been babysitting sick grandson so may not get to try this for a while. I'll 
make some inside measurements tomorrow.

Bill
> -----Original Message-----
> From: Bill Hosking [mailto:hoskingb at earthlink.net]
> Sent: Wednesday, November 15, 2006 10:31 PM
> To: will at beals5.com; TAPR Weather Station SIG Mailing List
> Subject: Re: [wxsig] Still looking for solution :-(
>
> Yeah, that is the problem trying to draw in text form (shoulda gone to
> courier).
> First - the x1w2 and temp/wind sensors have pass-through connectors, with
> that understood...
>
> From T238
> about 50-60 ft of flat 4-wire phone cable, crimped connectors
> x1w2 (pass through) humidity sensor
> about 20 ft of same cable
> wind/temp module (pass through)
> 6 ft cable (same stuff)
> Rain Gauge
>
> Without the humidity sensor turned on, temp, wind, and rain work 
> perfectly.
> Turn on humidity sensor, system hangs at the "wait a moment" prompt
>
> Bill
> ----- Original Message -----
> From: "Will Beals" <will at beals5.com>
> To: "'TAPR Weather Station SIG Mailing List'" <wxsig at lists.tapr.org>
> Sent: Wednesday, November 15, 2006 9:32 PM
> Subject: RE: [wxsig] Still looking for solution :-(
>
>
>> Bill:
>>
>> Hopefully we can figure something out that won't require drilling holes
>> and
>> venturing into crawlways!
>>
>> Unfortunately your diagram didn't come out to well, can you elaborate in 
>> a
>> different format?
>>
>> T238 Controller
>> ?? Feet of cable
>> Rain gauge
>> ?? Feet of cable
>> X1W2 sensor with humidity
>> ?? Feet of cable
>> Is there something more?
>>
>
>
>
>
>
>