[wxsig] Screw Sizes

[Arnold Harding]

Try a hobby shop.  They have sizes down to 00-90

----- Original Message ----- 
From: Ken.A.Brown at noaa.gov 
To: TAPR Weather Station SIG Mailing List 
Sent: Tuesday, December 25, 2007 6:09 PM
Subject: Re: [wxsig] Screw Sizes



These screws are much smaller than #6, and I tried known #4-40
which are also too large.  Some known #2 screws fit but I don't 
know for sure the threads per inch.  I suspect, as stated below,
they are #2-56.  My usual solution to this kind of problem is 
to take one fastener to Ace Hardware for a match but I'm not
sure they carry #2 size.

Ken 


----- Original Message -----
From: Peter Lutz <aa6av at sonic.net>
Date: Tuesday, December 25, 2007 11:55 pm
Subject: [wxsig] Screw Sizes

> I believe size 2 screws often have 56 threads / inch and
> size 3 screws have 48 threads / inch.
> 
> Kent Ochs wrote:
> > > The 238+ Assembly Guide lists the screws used in this project 
> as 
> 6-60.  I'm wondering if this is a typo as I am unable to locate any 
> suppliers of this size screw.  Could someone in the group clarify 
> the 
> screw size used in this project and possibly point me in the 
> direction 
> of a supplier if the size is indeed 6.60.
> > >
> > > Many thanks and happy holidays.
> > >
> > > Kent
> > > W9KAO
> 
> Peter
> -- 
> Peter Lutz AA6AV
> Meaning is homemade.
> 
> _______________________________________________
> wxsig mailing list
> wxsig at lists.tapr.org
> https://lists.tapr.org/cgi-bin/mailman/listinfo/wxsig
> 

_______________________________________________
wxsig mailing list
wxsig at lists.tapr.org
https://lists.tapr.org/cgi-bin/mailman/listinfo/wxsig