[wxsig] X1W-1 i-button clock

[Rasputin Novgorod]

Button says DS1994L+F5, and a bunch of other numbers.
T238+ does see the other sensors on the X1W-1 board;
I did install the enable jumper on the board.
/b


> Hmm, detection is automatic, If I see the DS1994 device ID I go read
> the
> time.  I think Dallas has a couple flavors of i-button clocks, did
> you get
> the DS1994?
> 
> will 
> 
> -----Original Message-----
> From: wxsig-bounces at lists.tapr.org
> [mailto:wxsig-bounces at lists.tapr.org] On
> Behalf Of Rasputin Novgorod
> Sent: Thursday, February 22, 2007 9:22 PM
> To: TAPR Weather Station SIG Mailing List
> Subject: Re: [wxsig] X1W-1 i-button clock
> 
> 
> I put an i-button clock on my X1W-1 board. But my T238+
> controller/display
> doesn't seem to find it. I have to reset the time, every time I power
> it up.
> In configuration I didn't see anything to initialize to program the
> ibutton.
> 
> Sincerely
> /b
> 
> 
> 
>  
>
____________________________________________________________________________
> ________
> Now that's room service!  Choose from over 150,000 hotels in 45,000
> destinations on Yahoo! Travel to find your fit.
> http://farechase.yahoo.com/promo-generic-14795097
> 
> _______________________________________________
> wxsig mailing list
> wxsig at lists.tapr.org
> https://lists.tapr.org/cgi-bin/mailman/listinfo/wxsig
> 
> 
> 
> 
> _______________________________________________
> wxsig mailing list
> wxsig at lists.tapr.org
> https://lists.tapr.org/cgi-bin/mailman/listinfo/wxsig
> 



 
____________________________________________________________________________________
Cheap talk?
Check out Yahoo! Messenger's low PC-to-Phone call rates.
http://voice.yahoo.com